Compared to the WiFi 5 extender, the Netgear EAX12 Setup‘s 4 Stream WiFi 6 mesh performs better. In addition, the Netgear EAX12 has OFDMA technology, which enables you to connect many devices to your WiFi network. As a result, you benefit from the effective data transfer across several devices at once. Once the Netgear EAX12 extender setup is finished, you may utilize the 880 MHz dual-core processor’s raw power.
Netgear EAX12 Extender Setup-Manual Steps
- Prior to connecting the Netgear EAX12 Extender, make sure it is powered on.
- Establish a WiFi connection between your device and the extender.
- Open your preferred browser and go to mywifiext.net.
- To set up the extender, pick your current WiFi network and input its password by following the on-screen instructions.
- Wait for the WiFi connection extender’s connection.
- After connecting, move the extender to the best coverage area.
- Check that the extended WiFi network is set up correctly using your devices.
NOTE : If you need any help regarding your wavelink wifi range extender so get in touch with the technician or visit the official web site that is mywifiext
Netgear EAX12 Extender Setup-WPS Steps
- When the Power LED solidifies, plug in the Netgear EAX12 Extender.
- Press the WPS button on the extender once the WPS LED starts to blink
- Press the WPS button for two minutes.
- Wait for the WPS LED on the extender to turn solid to indicate that the connection was successful.
- Move the extender to a better spot to get coverage.
- Link your devices to the WiFi network that is extended.
Login Steps For Netgear EAX12 AX1600 Extender
- Connect your mobile device to the Netgear EAX12 Extender’s WiFi connection.
- Type mywifiext.net in the address bar of an open web browser.
- Click Log In after entering the default password and username.
- Go through the settings for using your extender.
- Adjust WiFi setup or firmware updates as necessary.
- After that, you may use the dashboard to check on your network or make more changes.
Netgear AX1600 WiFi Range Extender Firmware Update
- Link the device to the WiFi network of the Netgear AX1600 Extender.
- Enter mywifiext.net setup in your internet browser’s Address bar.
- Enter your password and username to log in.
- Go to the Administration or Settings section.
- By choosing Firmware Update and following the on-screen instructions, the latest version of firmware can be obtained and installed.
- After the update is complete, wait and resume the extender if necessary.
Reset Process Netgear EAX12 AX1600
- Locate the reset button on the Netgear EAX12 AX1600 Extender.
- Click and hold the reset button for approximately ten seconds using a paperclip.
- As soon as the power light starts to slowly blink, release the button.
- Wait for the reboot and factory reset of the extender.
- Change the extender’s settings as required.
